Ensuring that your you have collected quality data while you are in the field will make all the difference in your final outputs. Detecting these issues before leaving the field could save you a trip back to the field to re-fly. There are many scenarios where the flight environment, hardware, or software will cause issues in your source data that makes it all or partially unusable.
Missed triggers in certain sections of the field- Caused by hardware or software
Images come off the drone to dark or light- Insufficient camera settings used
Vignetting is present in your source images- Caused by environment or time of day
To analyze your data in the field you will need to bring a laptop computer to the location. Make sure to install PrecisionViewer to this computer for analyzing the data. Below we will go step by step through the process of backing up and verifying your data in field right after your flight.
Data Backup Procedures
- Once the drone has landed and is powered down remove the Micro SD card from the device and plug it into your computer.
- Open the SD card and ensure that images were actually taken throughout the mission.
- Create a file structure on your Desktop to backup the data. Include pertinent information of flight in the filename- Sensor, Field Name, Altitude...
- Copy all images from the DCIM folder of your Micro SD card to the designated folder on your desktop.
- Once you are absolutely sure that all files were backed up successfully you should clear the Micro SD card of all data. Eject the Micro SD card from your computer and put it back into the drone.
Verification of Data Quality
- In your desktop folder turn on "Large Icons" in the file viewer and skim through images looking for light changes, blurriness, vignetting, or any other artifacts. For more information on recognizing these effects in your source imagery see Guidelines of a Quality Orthomosaic section of our knowledge base.
- If you find only a small number of these problem images you can delete them and try to work with the data anyways. If you see that a huge portion of your images have issues this may be a good reason for a re flight of the field. When in doubt during this process it is always safer to refly and collect more than enough data.
- Now we open the data in PrecisionViewer to analyze the trigger locations and flight track across the field. To start open PrecisionViewer and click "Add Survey"
- "Choose Image" by navigating to your desktop backup folder and selecting all images from this survey. Once added to the table scroll through paying attention to any warning symbols or major altitude changes.
- Usually your camera parameters will feed through automatically. If not choose the corresponding camera model and sensor group- Importance of labeling your folders with this information
- If you plan to treat this as your upload in the field choose the 2D or 3D depending on desired outputs
- Your survey will appear as an icon once properly added to PrecisionViewer. To view the triggering map of your flight click the Eye Ball icon on the surveys thumbnail.
- This will give you a rough layout of images across your area of interest. Each white tick mark on the screen shows a trigger of the drones camera. This map will illustrate to you any missed triggers or coverage on your area of interest.